Plastic Injection Moulding Machine - bench mounting. Hydraulically operated from a commercial single-phase, 240 volt (Savery Ltd) power-pack, 3/4 h.p. 55 bar working pressure. The 600-Watt heaters are regulated by an adjustable temperature controller and monitored by a built-in barrel thermocouple. The pellets can be fed from a simple automatic hopper feed for shot weights up to 10 gm or manually via a feed tube for heavier mouldings when the front tie rods are used to support the additional ram forces. (see pictures). The ram is 28 mm diameter with a stroke of 50 mm that allows the flow of pellets into the heating chamber. Throat depth in the work area is 115 mm, maximum mould height is 110 mm above platen which measures 230 mm wide X 190 mm deep. The whole unit can be powered from the domestic mains using about 6 amps. The complete unit is mounted on a fully castor based frame for easy manoeuvring and weighs about 150 kg. Measuring 70 cm wide by 80 cm long and 94 cm to bench top with an overall height of 183 cm. The whole unit can easily be stripped down to small components for transport. A clear polycarbonate safety shield has been removed to show the features more clearly also included is a photo of components recently moulded in HDPE at 200 degree C. A new PAT certificate for the power pack and heater system is included. All the hydraulic pipes and control valves are new and to the latest specifications. Working demonstrations a pleasure - by prior appointment near Thetford, Norfolk.