Myford Super 7 lathe. Mounted on the maker's cabinet stand with a deep chip tray and levelling blocks. Single-phase motor and a Dewhurst reversing switch. Very well equipped with a 3-jaw chuck, the correct half-depth body 6-inch Burnerd independent 4-jaw chuck, two Myford Milling slides, one with a double swivel, the other fixed - accompanying these is the correct milling slide raiser block and a Myford machine vice; quick-set toolpost with 7 tool holders, collet set, fixed steady, large and small faceplates, catchplate, Morse taper test bar, a new spare chuck backplate, tailstock chuck, tailstock rotating centre, Myford angle plate, coolant box, Morse centres, screwcutting changewheels, tailstock sliding die holder, The makers Manual, a copy of the Myford Series 7 book. and Myford oils. I bought this S7 in December 2005 and only used it in 2006. It has since sat in my garage not doing a lot. It's heavy and needs strong backs - a prolapsed disc means I can't help with shifting it. £1400 ovno. Collection only from Abergavenny.

Myford Screwcutting GearboxBought in April 2019 but never fitted or used. Includes the box, gears, shortened screw shaft, cover, and the manual as seen in the photographs. £600 no offers.

Collection from Abergavenny.
Mark on 07854-033716 or email dvarkholm@yahoo.co.uk