Colchester Bantam Lathe 5.75" x 20" metric specification and mounted on the maker's stand with a stainless steel backsplash with 2 shelves. The lathe is still in the maker's paint finish, in very good condition and everything works as it should - and is a pleasure to use.

Warco "Super Min Lathe" with variable-speed drive and in hardly-used condition and with an excellent specification: mounted on a chip tray with a full-length splashback. 90 mm centre height and 350 mm between centres. Speeds 50 to 1100 r.p.m in the backgear-driven low-speed range and 100 to 2500 r.p.m in high with a digital rev counter. 3 Morse headstock taper, No. 2Morse tailstock. 3-jaw chuck, thread-dial indicator, 4-way toolpost, changewheels, centres, two tailstock chucks, tailstock rotating centre, sliding tailstock die holder, and turning tools etc.

For Sale: Harrison M250 Lathe 5.7" x 30" (long bed). Mounted on the maker's stand with a full-length splashback, hardened bed, infinitely variable-speed drive from a 1-phase to 3-phase converter, a 2-axis DRO and dual inch/metric feed dials.

Myford Super 7BPXF Long Bed Lathe - Serial No. SKL 126833 3.5" x 30" fitted with an Imperial screw-cutting gearbox with transposing changewheels for metric and BA pitches and power cross feed. Mounted on the maker's industrial cabinet stand, chip tray, raiser blocks and 1-phase electrics. In excellent condition with unworn bedways and in the maker's paint finish.

New, unused Newton-Tesla 1 h.p. (750 Watts) 3-phase, 230-volt 1400 r.p.m motor on a resilient, vibration-reducing mount and with a 5/8" shaft. Suitable for Myford 7 Series and Boxford lathes, etc. This motor was bought as part of a Newton Tesla VF drive for my Myford 254 Plus, but the lathe came fitted with a 3-phase motor and I used that instead. This motor has been stored in my shed for several years, so it looks a bit tired, but it is absolutely new and unused. £50 Phone: 01903 746436  or  07771 695485

Myford 254S lathe 4.75" x 21" fitted with a full screwcutting gearbox with an enclosed leadscrew and a separate power-shaft drive to the sliding and power cross feeds, a hardened bed, extra large micrometer dials, a 26 mm spindle bore and single-phase electrics. Very well equipped with 3-jaw chuck  4-jaw chuck, fixed steady, travelling steady, an Emco milling slide, quick-set toolpost, 4-way toolpost, and all the original tooling and accessories used by the last owner as shown in the photographs.