Parts: Drive Belts

Prefabricated drive belts in stock. We also sell custom drive belts made to your specification.

If you have any questions about your order, please don't hesitate to get in touch through the contact form.

Naerok, NuTools, Warco, Seeley and Multico Bandsaw Drive belt

Round drive belt for the small but popular Naerok, NuTools, Warco, Seeley and Multico branded bandsaws. This is the very best quality, Swiss-made Polycord.
We have determined that the Naerok and NuTools versions had a belt made from 7 mm diameter material in the following lengths: 650, 660, 670 and 680 mm. However, it's important to check the length you need carefully and tick the right box.

Please take care to measure the belt and select the appropriate length below.

£28.80

Raglan Little John Lathe Drive Belt

The correct variable-speed drive belt for the Little John Mk.1 and Mk.2 Models. These belts are high-quality, industrial-grade belts made in Europe.   An installation tip: The manual suggests swivelling the layshaft housing about bolt 'D'. However, a better solution is to remove the grub screw (at the rear) securing the shaft to the housing; the housing can then be slid off the layshaft allowing it to move further, thus giving enough clearance to remove & refit the belt.

£69.00

Miniature V-Belts

Mini V-belts, 8 mm across the top surface - as used on a wide variety of small machine-tool and in other applications. High-quality, genuine European-made belts. These belts can be difficult to source, but we aim to keep stock of all the sizes listed. The post price covers the shipping of three belts. Click the down arrow in the box showing the 375 mm belt to see the range of sizes available.

£14.40

Myford ML8 Drive Belt

For the Myford ML8 lathe the new, improved metal-pin T-link belting is ideal. It's a sectional belt so no dismantling is needed to fit it. For lathes on the maker's stand 1.2 metres is the length needed. If mounted on a home-made bench with a thick wooden top, 1.3 metres is usually sufficient. The width required is 1/2" (13 mm) = an "A" section.

£94.80

Kennedy Hexacut Saw Belt

For the more common Kennedy "Hexacut" Model 60 hacksaw the flat belt is normally 1" (25 mm) wide and 21.8" long (554 mm) - however, because the size may have changed over the years, it would be safer to measure yours to get an exact figure. As the belts are custom-made, if you order the wrong length a refund is not possible. An accurate measurement can be taken around the pulleys with a strip of paper stretched around, overlapped, marked, and then carefully measured.

£26.40